MAPCO 16732HPS Thin and shorter drive shaft right VW Golf 4 R32 / Audi A3 8L / TT 8N Quattro

MAPCO 16732HPS Thin & shorter drive shaft right VW Golf 4 R32 / Audi A3 8L / TT 8N Quattro
The car drive/cardan shaft is used to transmit power between the gearbox and the driven wheel and is part of the drive train. Cardan shafts consist of the cardan shaft tube with sliding piece and the joints. Two-part cardan shafts are often used. By dividing the cardan shaft, low-vibration operation is achieved and noise is avoided. Cardan shaft damage occurs when the sleeves are damaged. The typical damage pattern shows traces of grease, particularly on the front vehicle doors, which are thrown out by the torn sleeve when the steering is fully turned. Penetrating water emulsifies with the grease; dirt also causes wear on the sliding surfaces of the joint. Signs of incipient damage can also be cracking noises when the load changes. Porous sleeves should be replaced soon.

Article information:

Installation side: front axle right

Length: 604 mm

Bore diameter: 10.5 mm

Thread size: M16x1.5

External toothing wheel side: 36

Seal ring diameter: 59.5 mm

Number of bores: 6

Bore circle diameter: 94 mm

Chassis: for vehicles with lowered chassis

for shaft diameter: 27 mm

Joint diameter wheel side: 98 mm

Joint diameter gearbox side: 108 mm

Suitable for the following vehicles:

AUDI TT (8N3) 1.8 T

AUDI TT Roadster (8N9) 1.8 T

AUDI TT (8N3) 1.8 T quattro

AUDI TT Roadster (8N9) 1.8 T quattro

AUDI TT (8N3) 1.8 T quattro

VW GOLF IV (1J1) 3.2 R32 4motion

AUDI TT (8N3) 3.2 VR6 quattro
AUDI A3 (8L1) S3 quattro
AUDI TT Roadster (8N9) 1.8 T quattro
AUDI TT Roadster (8N9) 3.2 VR6 quattro
AUDI TT (8N3) 1.8 T
AUDI TT Roadster (8N9) 1.8 T
AUDI TT (8N3) 1.8 T quattro
AUDI TT Roadster (8N9) 1.8 T quattro

If the car is not listed, please send a copy of the vehicle registration document by email to shop@schalk-tuning.de before ordering or at least the chassis number and KBA numbers or please call us beforehand: 03476 813028.