16756HPS Thin drive shaft right for VW Golf 4 Bora 1.9 TDI with 5 speed switch

MAPCO 16756HPS Thin drive shaft right for VW Golf IV 4 Bora 1.9 TDI with 5-speed switch
The car drive/cardan shaft is used to transmit power between the gearbox and the driven wheel and is part of the drive train. Cardan shafts consist of the cardan shaft tube with sliding piece and the joints. Two-part cardan shafts are often used. By dividing the cardan shaft, low-vibration operation is achieved and noise is avoided. Cardan shaft damage occurs when the sleeves are damaged. The typical damage pattern is particularly evident on the front vehicle doors, with traces of grease being thrown out by the torn sleeve when the steering is fully turned. Penetrating water emulsifies with the grease; dirt also causes wear on the sliding surfaces of the joint. Signs of incipient damage can also be cracking noises when the load changes. Porous sleeves should be replaced soon.

Article information:

Installation side: front axle right

Length: 815 mm

Thread size: M20x1.5

External toothing wheel side: 36

Seal ring diameter: 53 mm

Joint diameter wheel side: 90 mm

Joint diameter gearbox side: 100 mm

Bore diameter: 8.2 mm

Number of bores: 6

Bolt circle diameter: 86 mm

for shaft diameter: 27 mm

Chassis: for vehicles with lowered chassis

Suitable for the following vehicles:

VW GOLF IV Variant (1J5) 1.9 TDI

VW GOLF IV (1J1) 1.9 TDI

AUDI A3 (8L1) 1.8

VW GOLF IV (1J1) 2.0

VW GOLF IV Variant (1J5) 1.9 TDI

VW NEW BEETLE (9C1, 1C1) 2.0

SKODA OCTAVIA I Combi (1U5) 1.9 TDI
SKODA OCTAVIA I Combi (1U5) 2.0
AUDI A3 (8L1) 1.9 TDI
SKODA OCTAVIA I Combi (1U5) 1.9 TDI
AUDI A3 (8L1) 1.9 TDI
VW BORA (1J2) 2.0
VW GOLF IV Variant (1J5) 2.0
VW GOLF IV Variant (1J5) 2.0 Bi-Fuel
VW GOLF IV (1J1) 1.9 TDI
SEAT LEON (1M1) 1.9 TDI
VW NEW BEETLE Cabriolet (1Y7) 2.0
SKODA OCTAVIA I Combi (1U5) 1.9 TDI
SKODA OCTAVIA I (1U2) 2.0

If the car is not listed, please send a copy of the vehicle registration document by email to shop@schalk-tuning.de or at least the chassis number and KBA numbers or please call us beforehand: 03476 813028.