16792HPS Thin and 1cm shorter drive shaft PTO shaft right Golf 7 / Audi A3 8V

MAPCO 16792HPS Thin and 1cm shorter drive shaft, right-hand drive shaft, Golf 5/6/7 Touran Scirocco Passat 3C Audi A3 8P 8V Skoda Octavia II 1Z Octavia III 5E Seat Leon 1P 5F Toledo III 5P Altea 5P, right
The car drive shaft/cardan shaft is used to transmit power between the gearbox and the driven wheel and is part of the drive train. Cardan shafts consist of the cardan shaft tube with sliding piece and the joints. Two-part cardan shafts are often used. By dividing the cardan shaft, low-vibration operation is achieved and noise is avoided. Cardan shaft damage occurs when the sleeves are damaged. The typical damage pattern shows traces of grease, particularly on the front vehicle doors, which are thrown out by the torn sleeve when the steering is fully turned. Penetrating water emulsifies with the grease; dirt also causes wear on the sliding surfaces of the joint. Signs of incipient damage can also include cracking noises when the load changes. Porous cuffs should be replaced soon.

Article information:

Installation side: front axle right
Bore diameter: 10.5 mm
Thread size: M16x1.5
External toothing wheel side: 36.0
Seal ring diameter: 59.5 mm
Number of bores: 6.0
Bolt circle diameter: 94.0 mm
Chassis: for vehicles with lowered chassis
for shaft diameter: 27.0 mm
Joint diameter wheel side: 98.0 mm
Joint diameter gearbox side: 108.0 mm
Suitable for the following vehicles:

VW GOLF VI (5K1) 2.0 GTi
VW GOLF VII (5G1, BQ1, BE1, BE2) 2.0 GTI
SKODA OCTAVIA III Combi (5E5) 2.0 TSI RS
VW GOLF VI (5K1) 2.0 GTi
VW SCIROCCO (137, 138) 2.0 TSI AUDI A3 Sportback (8VA, 8VF) 1.8 TFSI SEAT LEON (5F1) 1.8 TSI VW GOLF VI Cabriolet (517) 2.0 GTI SKODA OCTAVIA III Combi (5E5) 1.8 TSI VW SCIROCCO (137, 138) 2.0 TSI VW EOS (1F7, 1F8) 2.0 TSI VW BE ETLE (5C1, 5C2) 2.0 TSI SEAT LEON ST (5F8) 1.8 TSI SEAT LEON (5F1) 2.0 Cupra VW SCIROCCO (137, 138) 2.0 R AUDI A3 (8V1, 8VK) 1.8 TFSI SEAT LEON SC (5F5) 1.8 TSI AUDI A3 Cabriolet (8V7, 8VE) 1.8 TFSI
SEAT LEON SC (5F5) 2.0 Cupra

If the car is not listed, please send a copy of the vehicle registration document by email to shop@schalk-tuning.de before ordering or at least the chassis number and KBA numbers or please call us beforehand: 03476 813028.