MAPCO 16776 Thin + short drive shaft Right drive shaft VW Golf 3 VR6 GTI Plus axle

MAPCO 16776 Thin + short drive shaft, right-hand drive shaft, VW Golf 3 VR6 GTI Plus axle
The car drive/cardan shaft is used to transmit power between the gearbox and the driven wheel and is part of the drive train. Cardan shafts consist of the cardan shaft tube with sliding piece and the joints. Two-part cardan shafts are often used. The division of the cardan shaft ensures low-vibration operation and prevents noise. Cardan shaft damage occurs when the sleeves are damaged. The typical damage pattern shows traces of grease, particularly on the front vehicle doors, which are thrown out by the torn sleeve when the steering is fully turned. Penetrating water emulsifies with the grease; dirt also causes wear on the sliding surfaces of the joint. Signs of incipient damage can also be cracking noises when the load changes. Porous sleeves should be replaced soon.

Article information:

Installation side: front axle right
Length: 768.0 mm
Thread size: M20x1.5
External toothing wheel side: 36.0
Bore diameter: 8.2 mm
Number of bores: 6
Bore circle diameter: 86 mm
Chassis: for vehicles with lowered chassis
Joint diameter wheel side: 90.0 mm
Joint diameter gearbox side: 100 mm
Suitable for the following vehicles:

VW GOLF IV Cabriolet (1E7) 2.0
VW GOLF III (1H1) 2.8 VR6
VW VENTO (1H2) 2.0
W GOLF III Variant (1H5) 2.0
VW GOLF III (1H1) 2.0 GTI 16V
VW GOLF III (1H1) 2.9 VR6 Syncro (1HX1)
VW VENTO (1H2) 2.8 VR6
VW GOLF III Variant (1H5) 2.9 VR6 Syncro
If your car is not listed, please send a copy of the vehicle registration document to shop@schalk-tuning.de before ordering or at least the chassis number and KBA numbers or please call us beforehand: 03476 813028.