MAPCO 16796HPS Thin + short drive shaft right VW Polo 6R Audi A1

MAPCO 16796HPS Thin + short drive shaft right VW Polo 6R Audi A1
The car drive/cardan shaft is used to transmit power between the gearbox and the driven wheel and is part of the drive train. Cardan shafts consist of the cardan shaft tube with sliding piece and the joints. Two-part cardan shafts are often used. The division of the cardan shaft ensures low-vibration operation and prevents noise. Cardan shaft damage occurs when the sleeves are damaged. The typical damage pattern shows traces of grease, particularly on the front vehicle doors, which are thrown out by the torn sleeve when the steering is fully turned. Penetrating water emulsifies with the grease; dirt also causes wear on the sliding surfaces of the joint. Signs of incipient damage can also be cracking noises when the load changes. Porous sleeves should be replaced soon.

Article information:

Installation side: front axle right
Length: 775 mm
Thread size: M16x1.5
External toothing wheel side: 36
Seal ring diameter: 52 mm
Number of holes: 6
Bolt circle diameter: 94 mm
Chassis: for vehicles with lowered chassis
for shaft diameter: 27 mm
Joint diameter wheel side: 98 mm
Joint diameter gearbox side: 108 mm
Suitable for the following vehicles:

VW POLO (6R1, 6C1) 1.6 TDI
AUDI A1 Sportback (8XA, 8XF) 1.6 TDI
SKODA RAPID Spaceback (NH1) 1.6 TDI
VW POLO (6R1, 6C1) 1.4 GTI
AUDI A1 (8X1, 8XK) 1.6 TDI
VW POLO (6R1, 6C1) 1.8 GTI AUDI A1 Sportback (8XA, 8XF) 1.4 TFSI AUDI A1 Sportback (8XA, 8XF) 1.6 TDI SEAT IBIZA IV SPORTCOUPE (6J1, 6P5) 1.4 TSI Cupra VW POLO (6R1, 6C1) 2.0 R WRC AUDI A1 Sportback (8XA, 8XF) 2.0 TDI VW POLO (6R1, 6C1) 1.4 TSI AUDI A1 Sportback (8XA, 8XF) 1.4 TFSI AUDI A1 (8X1, 8XK) 1.4 TFSI VW POLO (6R1, 6C1) 1.4 TSI SEAT IBIZA IV SPORTCOUPE (6J1, 6P5) 1.4 TSI SEAT IBIZA IV (6J5, 6P 1) 1.4 TSI
AUDI A1 (8X1, 8XK) 1.6 TDI
AUDI A1 (8X1, 8XK) 1.4 TFSI

If the car is not listed, please send a copy of the vehicle registration document to shop@schalk-tuning.de before ordering or at least the chassis number and KBA numbers or please call us beforehand: 03476 813028.