16848HPS shorter & thin drive shaft, front right, VW Golf 5/6 with 1.6, 1.9 TDI

MAPCO 16848HPS shorter & thin drive shaft, front right, VW Golf 5/6 with 1.6, 1.9 TDI
The car drive/cardan shaft is used to transmit power between the gearbox and the driven wheel and is part of the drive train. Cardan shafts consist of the cardan shaft tube with sliding piece and the joints. Two-part cardan shafts are often used. The division of the cardan shaft ensures low-vibration operation and prevents noise. Cardan shaft damage occurs when the sleeves are damaged. The typical damage pattern is traces of grease, particularly on the front vehicle doors, which are thrown out by the torn sleeve when the steering is fully turned. Penetrating water emulsifies with the grease; dirt also causes wear on the sliding surfaces of the joint. Signs of incipient damage can also be cracking noises when the load changes. Porous sleeves should be replaced soon.

Article information:

Installation side: front axle right

Length: 803.0 mm

Bore diameter: 8.2 mm

Thread size: M16X1.5

External toothing wheel side: 36

Seal ring diameter: 59.5 mm

Number of bores: 6

Bore circle diameter: 86 mm

Chassis: for vehicles with lowered chassis

for shaft diameter: 27.0 mm

Joint diameter wheel side: 90 mm

Joint diameter gearbox side: 100 mm

Suitable for the following vehicles:

VW GOLF V (1K1) 1.9 TDI

VW GOLF VI (5K1) 1.6 TDI

VW GOLF PLUS (5M1, 521) 1.9 TDI

VW GOLF V Variant (1K5) 1.9 TDI

SKODA OCTAVIA II Combi (1Z5) 1.9 TDI

AUDI A3 (8P1) 1.9 TDI AUDI A3 Sportback (8PA) 1.9 TDI VW GOLF V (1K1) 1.9 TDI VW SCIROCCO (137, 138) 1.4 TSI SEAT LEON (1P1) 1.9 TDI SKODA OCTAVIA II (1Z3) 1.9 TDI SEAT ALTEA (5P1) 1.9 TDI VW JETTA III (1K2) 1. 9 TDI SEAT TOLEDO III (5P2) 1.9 TDI SEAT ALTEA XL (5P5, 5P8) 1.9 TDI VW GOLF PLUS (5M1, 521) 1.9 TDI AUDI A3 (8P1) 1.6 TDI AUDI A3 Sportback (8PA) 1.6 TDI VW GOLF V (1K1) 2.0 FSI 4motion VW PASSAT Variant (3C5) 2.0 FSI 4motion

If the car is not listed, please send a copy of the vehicle registration document by email to shop@schalk-tuning.de before ordering or at least the chassis number and KBA numbers or please call us beforehand: 03476 813028.